SPECT/CT에서 인공고관절에 대한 감쇠보정지도 (Attenuation Map)의 매개변수 변화에 따른 금속 인공물 (Metal Artifact)의 영향 평가

• 영문명: Evaluation of the Effect of Metal Artifacts Varying the Parameters of the Attenuation Map for the artificial Hip Joint in SPECT/CT
• 발행기관: 대한핵의학기술학회
• 저자명: 김상규(Sang Gyu Kim) 김정열(Jung Yul Kim) 박민수(Min Soo Park) 조승현(Seung Hyun Jo) 임한상(Han Sang Lim) 김재삼(Jae Sam Kim)
• 간행물 정보: 『핵의학기술』Vol.18 No.2, 3~7쪽, 전체 5쪽
• 주제분류: 의약학 > 방사선과학
• 파일형태: PDF
• 발행일자: 2014.11.30

영문 초록

Purpose SPECT/CT scan to be performed attenuation correction on the basis of CT induce an overestimation of the site due to the beam hardening artifact by metal cover and reduce the images quality. Therefore, this study using a phantom that has been inserted artificial hip joint investigated that effect on the SPECT/CT image causing by metal artifact for varying the parameters of the Attenuation Map. Materials and Methods Siemens Symbia T16 SPECT/CT equipment was used. Artificial hip joint was inserted to SPECT/PET phantom, 17 mm sphere of Bright Streak area in CT image was filled with Tc-99m so that the radiation activity was 8 times compared to background. And then Hot and Background was measured in varying Wide Beam Coefficient on Attenuation Map and RBR (Region to Background Ratio) of Metal and Non-Metal was calculated and analyzed depending on the presence or absence of the hip joint. Results It tended to hot count of Non-Metal and Metal to increase as the value of the manual mode is increased, hot count ratio with the group of both manual mode 0.5 and 0.4 is the best match. Also, in automatic mode, the ratio of RBRNon-Metal and RBRMetal was 1.135, statistically significant difference was not observed in the manual mode 0.5 and 0.4. Conclusion In the automatic mode of Wide Beam Coefficient in attenuation correction map, it was found that it is over-correction by 13.52%, it was possible to minimize the over-correction by the artifact in 0.5 and 0.4 of manual mode. Further studies should be performed in order to apply to a patient with the help of this and it is considered possible to reduce the over-correction by the metal artifact of an artificial hip joint for Hip-Resurfacing Arthroplasty patients, and to improve the diagnostic performance.

목차

서론

대상 및 방법

결과

고찰

결론

요약

REFERENCES

키워드

Attenuation Map Artificial Hip Joint Beam Hardening Artifact