Al 6061 재료의 절삭가공에서 최적절삭에 관한 연구

• 영문명: The Study on Optimum Machining in Cutting of Materials Al 6011
• 발행기관: 한국산업기술융합학회(구. 산업기술교육훈련학회)
• 저자명: 차대홍(Dea-Ryong Cha)
• 간행물 정보: 『산업기술연구논문지』산업기술교육훈련논문지 제20권 1호, 39~43쪽, 전체 5쪽
• 주제분류: 공학 > 공학일반
• 파일형태: PDF
• 발행일자: 2015.03.30

영문 초록

When materials AL 6061 was machined by the selected condition using the CCGT20404-T Insert Tip, The cutting resistance of three components was obtained from Dynamic strain amplifier of Tool Dynamometer in case of the data which was machined the selected conditions were stored into computer. if investigate the result and analyze them, or in summary, there were obtained the following conclusion. 1) The relation of a cutting speed and a cutting conditions is good at a cutting machinability when the cutting speed is higher. The relation of a cutting depth and a cutting condition is good at machinability when the cutting depth is lower. 2) Experimental results for materials in a cutting condition given in this experiments, cutting depth had a higher effect than the cutting speed and the feed rate. 3) When machining the material (Al 6061) in the present experimental conditions, the most favorable cutting conditions that a cutting power consumption and a cutting speed are small were a cutting speed 290m/min, a cutting depth 0.5mm and a feed rate 0.2mm/rev when using CCGTI 20404-R Insert Tip.

목차

Ⅰ. 서 론

Ⅱ. 실험장치 및 방법

Ⅲ. 실험결과 및 고찰

Ⅳ. 결 론

키워드

Surface Roughness 표면거칠기 Feed Rate 이송속도 Cutting Depth 절삭깊이 Cutting Speed 절삭속도